Stuart Hughes

 7¼" Sole Plates and Rail Clips

“We are using 35mm Ali Rail from Jeff Price along with your 3 degree fittings and pressure treated sleepers."

Oak Tree Railway

5" and 7¼" Screw Fit Track

“I used the PNP track system to construct a garden railway in 2007. The system was extremely simple to assemble and lent itself to setting up an efficient 'production line' to speed construction - If you can find some willing workers to assist!

Adrian Sant

PNP Tipper Wagon

“I purchased a second hand PNP tipper from Station Road Steam. I have to say it is a brilliant design and we are using it alot!"

Almond Blossom Railway

Richard Brewster

5" True Scale Railway

“I thought you might be interested in this project using your 5" True Scale Sleepers and Clip Fit Chairs. The railway is still under construction and I hope will be finished in time for the Summer. It will eventually go all around the house. Having previously constructed a raised track using wood and steel...

Edward Hodson

Hudson Cordite Paste Wagon

“I am interested in the 18" gauge railway which used to operate in the Royal Gunpowder Mills at Waltham Abbey. I have used your bearings and wheel sets to produce a model of the Hudson Cordite Paste Wagon supplied to the factory in 1939. Thanks to your materials the vehicle is free running and very stable. The attached pictures show the simple construction. 

Vacuum Brake Equipment

“This is a photo of my engine which uses your vacuum brake ejector. It has been in use for over three years and it has been very reliable, pulling some 18 to 20 inches of vacuum which is more than enough when passenger hauling to give good braking reliability”.

Vacuum Brake Equipment

Southern Railway Ballast Brake Van

“Here are some pictures of a project which uses Products from the PNP range.

 It was decided that a Brake Van could be built which would supply a Vacuum to a train which did not have a vacuum fitted locomotive. In this case it was ideal as the locomotive which would pull the Brake Van was only small.

Vacuum Brake Equipment

“Above is a photograph of the 7¼" gauge engine (Princess Coronation 'Duchess of Hamilton’) I have been working on during the past 12 years. It is now close to completion and I hope to get it running in time for Easter Bank Holiday. Both the tender and a driver’s truck (not shown) have been with PNP Railways vacuum brake system”.

Vacuum Brake Equipment

“As a customer of PNP railways I would like to give you some feedback on the PNR-4R 21" vacuum ejector, PNR-1G vacuum release valve and PNR-3P brake valve.  In 2006 I completed the building of a large 7¼" gauge steam locomotive to a Roger Marsh Tinkerbell type design.  I was looking to fit vacuum brakes to the loco and found the PNP product range to be ideally suited to my needs.  After a discussion over my intended use I was assured the vacuum ejector and valves would be suitable.